How To Solve Startup Problem In Windows 7

How To Solve Startup Problem In Windows 7-20
Now reboot your system and hopefully, the problem will be solved.Note: You can also use the command ‘bootrec /Rebuild Bcd’.CHKDSK is a system tool present in Windows which verifies the integrity of a volume and tries to fix logical system errors.

Tags: Creative Writing Freelance JobsHow To Write An Essay ReportEssays On Power CrisisWays To Reduce Bullying In School EssayMarketing Plan For Small Business SampleRhetorical Analysis Essay Food IncPersonal Essay Prompts Creative Writing

As explained earlier, this error usually occurs when your hard drive is not working properly or has bad sectors present.

We can use the CHKDSK utility using the command prompt and see if there are any present.

Start with the first one and work your way down accordingly.

Note: Before you move on to carrying out all the solutions listed below, make sure that you have not attached two hard drives onto the same computer where both contain their version of operating systems.

You can set your SATA hard drive to function in one of the three modes (AHCI, IDE, and RAID).

The IDE mode is the simplest mode available and in it, the hard drive is set to run as an IDE or Parallel ATA.After backing up your important data, you can either install a new version of Windows or try turning the processes back on and see what the problem was.SATA modes determine how your hard drive communicates with your computer.After executing these commands, run CHKDSK and see if this solves the problem at hand. If both the above solutions don’t work out, you can load your computer in Safe Mode and try clean booting.This boot allows your PC to turn on with a minimal set of drivers and programs.Carefully remove the hard drive, plug it into another computer and try running CHKDSK in it. Note: When you plug the hard drive in the new computer, make sure that the boot priority is set to that computer’s hard drive.Otherwise, you will be experiencing the same problem on that computer too.The Startup Repair tool repairs Windows 7 by replacing important operating system files that might be damaged or missing.Startup Repair is an easy diagnostic and repair tool to use when Windows 7 fails to start properly and you can't use Safe Mode.If Windows still doesn’t boot as required, you can perform solution 1 and 2 again.Make sure that you perform the CHKDSK operation either on all the drives or on the drive where your boot files are stored.


Comments How To Solve Startup Problem In Windows 7

The Latest from ©